OM-USB-2404-UI User's Guide
Functional Details
13
OM-USB-2404-UI circuitry
Analog input circuitry
The OM-USB-2404-UI is channel-to-channel isolated. Four 24-bit analog-to-digital converters (ADCs)
simultaneously sample all four analog input channels. An excitation circuit is enabled for all input modes that
require excitation. The ADC and excitation circuits are reconfigured in each mode to accommodate each sensor
type. Figure 7 shows the input circuitry for one channel.
Figure 7. Input circuitry for one channel
Voltage and current modes
In voltage and current modes, connect the signal source to the OM-USB-2404-UI across the HI and LO
terminals. The current is computed from the voltage that the ADC measures across an internal shunt resistor.
Voltage and current mode connections are shown in Figure 8.
Figure 8. Voltage and current mode connections
4-wire resistance and 4-wire RTD modes
4-wire resistance and 4-wire RTD modes source a current which varies based on the resistance of the load
between the EX+ and EX– terminals. The measured resistance is calculated from the resulting voltage reading.
These modes are not affected by lead wire resistance, because a negligible amount of current flows across the
HI and LO terminals due to the high impedance of the ADC. 4-wire resistance and 4-wire RTD mode
connections are shown in Figure 9.
Figure 9. 4-wire resistance and 4-wire RTD mode connections
