G. Locking thumbscrew
H. Data logger clamp
I. Pedestal
J. Magnets
K. Screw mounting holes
SETUP INSTRUCTIONS
ACTIVATE BATTERY
1. Use a very small Phillips-head screwdriver to remove the two
silver screws securing the grey battery compartment cover
(Fig. 1, Callout F) to the bottom of the data logger. Set the
screws aside, taking care not to lose them.
2. Carefully remove the battery compartment cover to expose the
“1/2AA” battery inside.
3. Remove the battery from the well. If the battery is covered by a
transparent plastic cover, remove and discard it. If not, proceed
to the next step.
4. Insert the battery in the well cathode (- side) first.
5. Replace the battery compartment cover and secure it with the
two silver screws.
5
PEDESTAL (TOP)
PEDESTAL (BOTTOM)
K
G
H
I
J
VB10 Manual_FINAL_080514_awb 8/5/14 12:06 PM Page 5
