1-4 Unit Startup
878395
Personal Daq User’s Manual
3) Attach Assembly to DIN Rail (Types NS 35, or NS 32)
Installing Base/Foot Assembly to a DIN Rail Mount
The following steps are based on the orientation illustrated above. Note that feet (FE-8) contain
rail catches
for
both NS 35 and NS 32 type DIN rails. In each case a different set of
rail catches
is used.
1.
Place the applicable
lower rail catch
of the feet onto the
lower lip
of the DIN rail.
2.
Push the entire base/foot assembly toward the DIN rail. The assembly will snap into position.
Removing Units from a Type NS 35 DIN Rail
1.
Push on both
Quick Release
sections of the FE-8 feet at the same time.
2.
Lightly pull the base/foot assembly away from the DIN rail.
Removing Units from a Type NS 32 DIN Rail
1.
Push up on the base/foot assembly.
2.
Lightly pull the base/foot assembly away from the DIN rail.
Connect PDQ Module (option)
CAUTION
The discharge of static electricity can damage some electronic components.
Semiconductor devices are especially susceptible to ESD damage. You should always
handle components carefully, and you should never touch connector pins or circuit
components unless you are following ESD guidelines in an appropriate ESD controlled
area. Such guidelines include the use of properly grounded mats and wrist straps,
ESD bags and cartons, and related procedures.
CAUTION
Never connect an expansion module to (or remove it from) a Personal Daq main unit
while the main unit is connected to a power source. Such action may result in
EEPROM errors and loss of calibration data.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
