Using the Screw-Terminal Blocks
You must remove the DBK215 module’s cover plate to access the screw terminal blocks.
This is described in steps 1 and 2 below.
1.
Remove the top inward screws from each of the 4 mounting brackets. See following figure.
The Cover Plate is Secured by 4 Srews
[2 Screws per-side]
To remove the cover plate you
must first remove the top
inward screw from each of the
4 mounting brackets.
2.
After the 4 screws have been removed, carefully remove the cover plate.
3.
As soon as the DBK215 cover is removed, verify that the Host Power LED is “Off.”
See following figure for location.
Host Power LED Location
4.
Make the wiring connections to the terminals. Refer to the board’s silkscreen and to
the pin correlations on the next few pages.
5.
Tighten the terminal block screws snug; but do not over-tighten.
6.
After all terminal connections are made and verified correct, return the cover to the unit and
secure in place with the 4 screws removed earlier. Tighten snug, but do not over-tighten.
Appendix A
948894
DBK215 A-5
Summary of Contents for OMB-DAQBOARD-3000 Series
