2
About The Meter
6
2.4.1 METER BUTTONS
SETPTS
Button
In the run mode, this button will sequentially recall the previous setpoint settings. As
necessary, use the
/pH
and
/mV
buttons to alter these settings, then press the
SETPTS
button to store new values.
Unless you press the
SETPTS
,
/pH
, or
/mV
button within 20 seconds, the meter will
scroll to setpoint 2 and then to the run mode.
/pH
Button
(for pH Controller)
In the run mode, this button will view pHvalue.
In the configuration mode, press this button to change the value of the flashing digit
shown on the display and/or toggle between menu choices, such as “
R.2=F
” or “
R.2=C
”
on RD.CF menu. When configuring your setpoint values, press the
/pH
button to
advance the flashing digit's value from 0 to 9 by 1.
/pH/ORP
Button
(for pH/ORP Controller)
In the run mode, this button will view pHvalue.
If you have a pH/ORP Controller: throughout this manual’s text, the
/pH/ORP
button is referenced as the
/pH
button.
To toggle between the pH and ORP values while in the “Run Mode” (Normal Operation).
Use this button also to change the value of the digits while in the “Setpoint” and “Menu”
(Configuration) Modes.
T/mV
Button
(for pH Controller)
In the run mode press the
T/mV
button to recall the mV value of your input signal.
Press the
T/mV
button a second time to recall the temperature value of your input.
In the configuration mode, press this button to scroll to the next digit.
T/mV
Button
(for pH/ORP Controller)
To view temperature while in the “Run Mode” (Normal Operation). Use this button also
to select the digit’s position while in the “Setpoint” and “Menu” (Configuration) Modes.
