VIR50-EU-EN-V2.0 9/11
11
Factory Default Setting
Use the
▲
and
▼
buttons to select either YES (revert to the factory default settings) or NO (cancel).
Press the ESC button to exit and save.
Measurement Settings
From the Video + IR, IR-only, or Dew Point modes, press the ENTER button to access the soft-key
screen. The Measurement Settings mode is represented by the middle icon. Use the arrow buttons
to scroll over to the middle icon (if it is not already highlighted.)
Press the ENTER button again when the middle icon is highlighted to access the Measurement
Settings mode as shown below.
Item Description
Emissivity set
Set the emissivity
Alarm High
Set the high alarm ON/OFF and set the alarm limit
Alarm Low
Set the low alarm ON/OFF and set the alarm limit
Laser
Enable or disable the laser pointer
Auto Mode
Lock the measurement ON
MAX/MIN
Display the highest (MAX) or lowest (MIN) IR temperature
AVG/DIF Display
Average
temperature or Differential IR temperature
Ambient TEMP/% RH
Display the air temperature and relative humidity
Dew-point/wet bulb
Display the dew-point and wet bulb temperature
Type K
Enable or disable the type-k contact thermocouple input
