Using the Infrared Thermometer/Transmitter
3
3-22
3.5.8 Storing Temperature Data on Command
(OS553A, OS554A, OS555A)
The thermometer can store up to 800 temperature data
points on command. This data is stored in the non-volatile
memory, so removing power will not affect or erase this
data. To store temperature data:
1.
Aim at the target and turn on the transmitter.
2.
If necessary, press the
key to increment the target
emissivity or press the
key to decrement the target
emissivity.
3.
Press and hold the
key until the Memory Display
Mode (MEM) appears.
4.
Press the
key to store the target temperature at the
memory location indicated. You will hear a beep to
verify that the data is stored. Then the memory location is
incremented by one.
5.
After all data is taken, press and hold the
key
until the Emissivity Display Mode (E) appears.
3.5.9 Reviewing Stored Temperature Data (OS553A,
OS554A, OS555A):
1.
Press the
key to go to the MEM display mode.
2
The upper display shows the next memory location to
store temperature data.
3.
Press the
key to go to previous memory locations.
The lower display will show the corresponding stored
temperature data at that location.
4.
Press the
key to go to the last memory location. The
lower display will show the current temperature. You can
now store temperature data by pressing the
key.
°
F
Summary of Contents for OS550A
