141
11.2 Fault and troubleshooting
Fault
Cause
Solution
Starting failure
Power failure
Wait for the power supply to be
restored.
Power switch is off
Turn on the power
The fuse of the power switch is blown.
Replace the burnt fuse.
The time set for the timed power-on has not arrived.
Replace the batteries.
The batteries of the remote controller are exhausted.
Wait or cancel the setting.
There is air blowing,
but the cooling/
heating effect is poor.
The temperature setting is inappropriate.
Set the temperature properly. Increase or
decrease the temperature. Read
Operating Methods for details.
The air inlet or outlet of the IDU or ODU is blocked
Remove the obstacles.
Doors and windows are open.
Close the doors and windows.
There is air blowing,
but the unit cannot
supply cold or hot air.
The air inlet or outlet of the IDU or
ODU is blocked.
Remove the obstacles and
perform the operation again.
Compressor 3-minute protection
Wait.
The temperature setting is
inappropriate.
Set the temperature properly.
Summary of Contents for OTEC IEMP-D Series
