16
17
Programmable Features (cont’d)
90 Seconds After Ignition OFF & Unlocking By Transmitter
(press TRUNK)
This feature allows the system to automatically engage the starter disable whether or not the doors
are locked. You can select it to engage 90 seconds after turning the ignition OFF and/or 90 seconds
after pressing UNLOCK on the transmitter.
Feature #10 Anti-Carjacking
Default setting:
OFF
(press
...
)
Options:
Ignition Activated Anti-Carjacking
(press LOCK)
Remote Activated Anti-Carjacking
(press UNLOCK)
Ignition & Remote Activated Anti-Carjacking
(press TRUNK)
This system offers 2 forms of anti-carjacking protection. One is automatically activated when the
igntion is turned on. The other is activated when you press and hold the “
...
” button for 3 seconds
while the ignition is on. You can even select to have both forms enabled for maximum security.
When activated, the carjacking sequence operates as follows:
- Under normal operation, pressing the valet switch once after activating the sequence (as se-
lected by the feature), will cancel the sequence immediately.
- If the sequence is not canceled, the horn will start chirping 53 seconds after activation. During
the next 7 seconds, the sequence can still be canceled with 1 press of the valet switch.
- At 60 seconds, it enters anti-carjacking mode and will honk the horn and flash the lights.
- At 90 seconds, the starter disable will engage. The only way to cancel the sequence is to turn
the ignition OFF, back ON, then within 10 seconds, press the valet switch. If you plan to utilize
this feature, it is ideal to mount the valet switch in a discreet location. Consult with the installer
about this.
NOTE: if the “
...
” button is configured for Panic, remote anti-carjack is reas
-
signed to pressing “LOCK” and “UNLOCK” simultaneously.
Feature #11
Parking lights for 30 seconds after unlock by transmitter
Default setting:
ON
(press LOCK)
Options:
OFF
(press UNLOCK)
This feature is defaulted so the flashing light output will stay on for 30 seconds after remotely
unlocking the doors.
Feature #12 “
...
“ button operates 3rd channel or panic
Default setting:
3rd Channel Pulse
(press LOCK)
Options:
3rd Channel Latch/Unlatch
(press UNLOCK)
3rd Channel 30 second output
(press TRUNK)
PANIC
(press
...
)
This feature configures the timing of the 3rd channel output. Alternatively, the “
...
“ button can be
configured to operate the PANIC feature. The 3rd channel output options should only be configured
by the installer.
Changing The Programmable Features
STEP 1 -
Make sure the system is in an unlocked state, not in valet mode, and
turn the vehicle’s ignition ON, then back OFF.
STEP 2 -
Within 7 seconds of STEP 1, press the valet switch 5 times. The horn
will honk and the status light will turn on.
STEP 3 -
Press the valet switch the number of times that corresponds with the
feature you’d like to access (5 times = feature #5). The horn will chirp
and the status light will flash the same number of times to confirm.
