3) Start the engine with the key; then turn the Tach Sense adjustment screw
slowly clockwise until the LED indicator illuminates solid.
- To increase sensitivity, thus the crank time, turn the adjustment screw
coun-
terclockwise.
- To decrease sensitivity, thus the crank time, turn the adjustment screw
17
22-Gauge
White Wire:
Parking Light Output
Connection Recommended.
The White wire is a +12 Volt output to the
vehicle’s exterior parking lights and its function is to visually confirm remote start
and Valet Mode operations. The parking lights are also used as indicators when
programming features. Connect the White wire to the vehicle’s 12 Volt parking
light circuit as shown in the accompanying diagrams. The correct wire will show
12 Volts only when the headlight switch is in the “Parking Light” and “Head Light”
positions. This wire can usually be found at the headlight switch, and various
other locations within the vehicle, such as the rear body harness or firewall
connector.
Caution:
When such a wire is located, be sure to also test that it is
non-rheostated: While metering the wire, operate the dash light dimmer control.
The correct wire will show no change in voltage when the dimmer is operated.
Some vehicles have a parking-light relay which is triggered by a Negative signal
from the headlight switch. In these vehicles, the White wire must be connected
after the relay, usually at the Fuse/Junction Block. Do NOT connect the White