22
22 Gauge
Red Wire:
+12 Volt Output For Optional Relay
Coil
Connection If Needed.
The Red wire supplies constant 12 Volts that
can be used to power the relay’s coil only- DO NOT use this Red wire for the
W I R I N G - 3 Wire Connector
22 Gauge
Blue Wire:
500mA Negative Ignition Output
Connection If Needed.
This 22 gauge Blue wire is a 500mA Negative out-
put having basically the same operation as the 12 gauge Blue Ignition output. If
two or more Primary Ignition wires are present in the vehicle an optional relay is
needed, connected to this wire as shown in the diagram on the next page.
This harness, which plugs into the Red 3-pin port on the control module, can
be used, if needed, to configure optional relays to energize additional Ignition
or Starter circuits. Also, Omega OEM security bypass interfaces use the Red
22 Gauge
Green Wire:
500mA Negative Starter Output
Connection If Needed.
This 22 gauge Green wire is a 500mA Negative
output, which has the same operation as the 12 gauge Green Starter output. If a
second Starter wire is present in the vehicle, an optional relay will be needed, con-
nected to the 22 gauge Green wire as shown in the diagram on the next page.
