Valet Switch:
Mount this switch in a location that’s easily accessible to the user. Route the wires
to the RS unit’s control module and plug the 2-wire connector into the matching
2-pin port on the control module. The Valet Switch is used to place the system
into Valet Mode and for Features Programming Mode. In everyday operation,
the “on” or “off” status of this switch controls Valet Mode. For the Features
Programming Mode, this switched is toggled “on” and “off” within 7 seconds of
the ignition switch being turned “Off”.
Valet Switch
The RS-3A has three programmable features. These features can be changed
when the unit is in Features Programming Mode by selecting the feature with the
valet switch, then changing its setting by pressing the brake pedal. Please note
that there are actually six features which are accessible, but only features #4 to
#6 apply to the RS-3A. The unused first three features are only applicable to the
RS-3A’s companion model, the RS-7K2.
Programmable Features
24
