9
12-Gauge
Green Wire:
Starter Output
Con-
nection Required
.
Connect the Green wire to the vehicle’s Starter wire. This
wire will show +12 Volts only when the ignition key is in the “Start” position. This
wire is also found in the ignition switch wiring harness (see diagram on previous
page). Some vehicles have a second Starter wire known as a “Cold Start” wire.
When this is encountered, an optional relay may be needed, configured to the
3-pin Red port, to energize the second Starter wire (pages 22-23).
Note:
If a security system is present which utilizes a starter interrupt circuit, the
Green wire must be connected to the Starter Motor side of the interrupt.
12-Gauge
Blue Wire:
Ignition Output
Con-
nection Required
.
Connect the Blue wire to the vehicle’s Ignition wire (also
known as “Primary Ignition”). This wire will show +12 Volts when the ignition key
is in the “Run” and “Start” positions and no voltage in the “Off” and “Accessory”
positions. This wire is found in the ignition switch wiring harness (see diagram
on previous page).
Note:
If two or more Primary Ignition wires are present, you will need to connect
an optional relay or relays to the 3-pin Red port (see pages 22-23).
