!! WARNINGS !!
Do not attempt to install the RS-4LX Remote Car Starter into a manual trans-
mission vehicle! Doing so could cause serious property damage, personal in-
jury, and will void all warranties!
Be aware of, and avoid, any airbag circuitry! Due to the fact that an installer
will not be in a normal, upright seated position, severe injury may occur in an
accidental airbag deployment!
The use of a Digital Multimeter (DMM) or Volt-Ohm Meter (VOM) instead of
a standard testlight is recommended. This can greatly reduce the risk of an
accidental airbag deployment or on-board computer damage.
Battery gases are explosive! Avoid sparks and do not smoke while working
near the vehicle's battery!
Always protect wires ran through the firewall from sharp metal edges and hot
parts of the engine! Always fuse positive wires at the battery or power source!
I N S T A L L A T I O N I N S T R U C T I O N S
Page - 8
Start
Run
30 Amp
15 Amp
Starter
Accessory
HVAC
Controls
Ignition #1- Coil
and Fuel Pump
Bat 1 Bat 2 Bat 3 Bat 4 Bat 5
20 Amp
Ignition Switch Schematic After Installing The RS-4LX:
Battery
30 Amp
30 Amp
Ignition #2 -
Engine
Computer
Yellow
Red
Green
10 Amp
Blower
Motor
Parking
Lights
Black
White
Blue
Relay
1
Relay
3
Relay
2
Lock
Acc.
Off
RS-4LX
Page - 33
!! WARNINGS !!
Do not attempt to install the RS-4LX Remote Car Starter into a manual trans-
mission vehicle! Doing so could cause serious property damage, personal in-
jury, and will void all warranties!
Be aware of, and avoid, any airbag circuitry! Due to the fact that an installer
will not be in a normal, upright seated position, severe injury may occur in an
accidental airbag deployment!
The use of a Digital Multimeter (DMM) or Volt-Ohm Meter (VOM) instead of
a standard testlight is recommended. This can greatly reduce the risk of an
accidental airbag deployment or on-board computer damage.
Battery gases are explosive! Avoid sparks and do not smoke while working
near the vehicle's battery!
Always protect wires ran through the firewall from sharp metal edges and hot
parts of the engine! Always fuse positive wires at the battery or power source!
I N S T A L L A T I O N I N S T R U C T I O N S
Page - 8
Start
Run
30 Amp
15 Amp
Starter
Accessory
HVAC
Controls
Ignition #1- Coil
and Fuel Pump
Bat 1 Bat 2 Bat 3 Bat 4 Bat 5
20 Amp
Ignition Switch Schematic After Installing The RS-4LX:
Battery
30 Amp
30 Amp
Ignition #2 -
Engine
Computer
Yellow
Red
Green
10 Amp
Blower
Motor
Parking
Lights
Black
White
Blue
Relay
1
Relay
3
Relay
2
Lock
Acc.
Off
RS-4LX
Page - 33
