Omega VRT400 SERIES, Instruction Manual

Open

8

9

SLOW JUICER ASSEMBLY

SLOW JUICER ASSEMBLY IN DETAIL

Align hopper front triangle with [   ] bowl triangle 

[   OPEN ] first and turn it to clockwise until it 

clicks so that the hopper triangle [   ] aligned 

with bowl triangle [Close   ]. 

Assemble the parts as following order : 

Bowl > Spinning Brush > Strainer. Make sure bowl 

triangle [   OPEN ] aligns with strainer triangle [   ].

Place the bowl in the base.

   A spinning brush can be assembled regardless 

of the direction.

Make sure to press the screw down into the 

strainer as in STEP 2. The hopper does not close 

properly when the screw does not fit in completely.

1

Insert extraction packing at the bottom of the bowl hard enough into the pulp outlet. 

Make sure bowl outer groove aligns with base bump completely

4

Align the hopper rear part with base completely as in below. 

The hopper will not close properly when the parts are not assembled correctly.

2,3

Assemble the parts in the order of bowl > spinning brush > strainer > squeezing screw > hopper 

(or assemble the spinning brush into the bowl then fit strainer bump in the bowl inner groove). 

Make sure all the triangles of bowl [   OPEN ], strainer [   ] and hopper [   ] are aligned in a vertical line.

Hopper 

rear part

Hopper

Strainer

Bowl

Squeezing Screw

Strainer 

bump

BOTTOM 

OF THE 

STRAINER

INSIDE THE 

BOWL

Bowl inner 

groove

Bowl outer groove

Base bump

Extraction 

packing

Spinning brush