22
Metal Parts
In the ultrasonic bath, preheat 1 part OmegaSupreme with 10 parts clean water to a
temperature of 150
˚F.
Place the metal parts into the basket with the cavity containing heaviest residue
facing the bottom of the basket.
Submerge the basket into the bath and rotate the housings (if applicable) keeping
them underneath the surface to allow air bubbles to be removed from the part.
Clean the part for 5 minutes.
Once completed, rotate the part 180
˚ if the part facing opposite the ultrasonic
transducers is heavily soiled.
If necessary, clean the part for an additional 5 minutes.
Once the part is cleaned, remove from the bath and rinse using water that is 150
˚F.
Blow off the excess water using compressed air.
Due to the heat of the metal, after being removed from the bath, it will dry quickly, on
its own (“flash dry”).
