AccuTrac / RhinoTrac Owner’s Manual
Page 5
AccuTrac EZ and RhinoTrac EZ tools
are designed for the exclusive use with fasteners and plates (washers) made by OMG Roofing Products. OMG Roofing
Products is not responsible for damage to the tool and/or improper installation caused from using fasteners and/or plates other than those recommended in this
manual.
AccuTrac EZ
is designed for use with 3-inch square AccuTrac Insulation Plates, and approved fasteners manufactured by OMG Roofing Products.
RhinoTrac EZ
is designed for use with specially coated, 3-inch round, RhinoBond Plates and approved fasteners manufactured by OMG Roofing Products.
POWER REQUIREMENTS
FASTENER COMPATIBILITY
CORD LENGTH
25-ft.
50-ft.
75-ft.
100-ft.
125-ft.
150-ft.
WIRE SIZE
18-Ga.
16-Ga.
14-Ga.
14-Ga.
12-Ga.
12-Ga.
INTENDED USE
AccuTrac EZ and RhinoTrac EZ tools
are intended for installing OMG Roofing Products Fasteners and Insulation Plates or RhinoBond Plates on commercial roofing
projects. Only fasteners and plates (i.e. washers) specified and provided by OMG Roofing Products are approved for use with these tools. Do not use these tools for
any other purpose.
AccuTrac EZ and RhinoTrac EZ tools can injure people and damage property. Please be sure that you and all crew members read and understand the instructions
in this manual (as well as those in the Owner’s Manual for the screw-gun component) before attempting to use these tools. Failure to follow all instructions could
result in property damage, serious injury, electric shock, or death.
PLEASE NOTE:
This manual deals only with the use and operation of the AccuTrac EZ and RhinoTrac EZ tool. For specific information about the use, operation, and
limitations of the screw-gun component of the tool, refer to the separate Owner’s Manual provided by the screw gun manufacturer, which has been included with
the tool.
AccuTools are compatible with the following fasteners manufactured by OMG Roofing Products. Maximum fastener length is 8-inches.
- Standard #12 RoofGrip Fasteners
- Heavy Duty #14 Roofing Fasteners
- Extra Heavy Duty (XHD) #15 Fasteners
Extension cords must be of adequate wire size for safety, to prevent loss of power and to avoid over-heating the tool. Refer to the chart below for the minimum wire
size requirements.
NOTICE
