MF 64
Author: Donato Gavino Murru donato.gavino.murru@omgitaly.com
Pag.
85
a
179
Use the up / down selector switch to move the roll up or down. Adjust the height of the centering
cones until they match the center of material roll.
Use the manual pneumatic command for blocking the roll on its unwinding axis.
If a non-finish rolls need to be removed from the system, beware not to
release it when the operator is near the axis of the roll. It could fall on the
operator. You need to seat the roll on the roll table without compress it
before releasing the roll from the axis. No Doing so may result equipment
damage or injury.
Up / down lifting roll
selector.
Maintain the selector to
go up or down the lifting
support.
In central position the
system is stopped.
Roll Lifting screws on the two sides
Pneumatic control and cylinder.
Roll Lifting columns.
After approaching the roll to the fixing
cone in a way that the extremities of the
cones enter in the roll center, use the
manual lever to advance the other cone.
