TOOL OPERATION
GET COMFORTABLE!
You are likely going to be using the RhinoBond Tool for several hours at a time. Make sure that the tool is set for your height and comfort level.
Adjust the handle height of the RhinoBond tool by loosening the clamps on both
sides of the handle. Gently adjust the handle position up or down for maximum
comfort. Lock the clamps into position and tighten, and you’re ready to go!
Avoid over-extending the handle by adjusting it slowly. Over-extending the handle can damage the activation button wiring and your RhinoBond tool.
When first powering up the RhinoBond tool, the main screen will show a status bar indicating tool startup progress.
If necessary, you can calibrate the touch screen at this time. To do so, touch this screen once to begin the calibration
process (see below).
Once startup is complete, the screen will display the “Language” selection screen.
TOUCH SCREEN CALIBRATION
Follow the on-screen instructions. Tap the dot when prompted. Three points of calibration are required to complete the process.
When complete, the tool will return to the “Start-Up” screen and when start-up is complete, display the “Language” selection screen.
SELECT LANGUAGE
Press the appropriate language button to select the desired language.
Once selected, the tool will display the “Ready Screen” in the chosen language.
NOTICE
RhinoBond Owner’s Manual - Page 8
