ENGLISH
Cod. 710.0150.01.00 Rev.03 – 09.2019
13 - 73
INTRODUCTION
This manual is an integral part of the dryer you bought, and must remain with the machine even if this will be resold.
It is strictly recommended that the qualified*personnel for installation maintenance and/or control will fully comply with
the contents of this manual and the prevention and safety rules in force in the country where the system will be used. In
this way, not only the usage of the machine will be rational, but also the service will result cost effective.
In case your dryer will present any kind of problem, please contact immediately a Service Centre Authorised by the
manufacturer.
Please note that, when necessary, the use of original spare parts will ensure efficiency and long duration to your dryer.
Due to the continuous technological evolution, the Manufacturer reserves the right to modify the specifications
contained in this manual without giving previous notice.
WARRANTY
Each product is delivered regularly tested, and covered by the warranty conditions specified on the sale list and/or on
the supply contract.
SYMBOLS USED IN THE MANUAL AND ON THE DRYER
Air entry point
Air outlet point
Read the Operators manual before attempt to start
up the machine and to perform any service
operation on the dryer.
Pay particular attention to components or systems
under pressure.
Pay particular attention to the indications preceded
by these symbols.
Pay particular attention to hot surfaces.
Installation, maintenance, and/or control operations
preceded< by these symbols must be performed
exclusively by qualified personnel*.
Pay particular attention to the risk of electric
shock.
Condensate drain point.
Rotation direction of the fan.
Pay particular attention to the risk of moving parts
Explosion risk.
Lifting point.
Don’t lift from this point.
Attention:
Before
performing
any
maintenance
operation
on
this
machine, do not forget to disconnect
the electric supply, to completely
discharge air pressure, and to refer to
the Operators manual.
* Personnel owning technical knowledge and being enough aware of rules and laws to ensure the needed safety during installation, maintenance and/or
control operations.
Summary of Contents for ED HP108
Page 2: ......
Page 55: ...Cod 710 0150 01 00 Rev 03 09 2019 53 73...
Page 61: ...Cod 710 0150 01 00 Rev 03 09 2019 59 73 3 2 3 3 1 2 3 4 2 5 6 7 ON OFF 10...
Page 63: ...Cod 710 0150 01 00 Rev 03 09 2019 61 73 1 2 3 1 2 3 4 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 4...
