11
DMAN-xxxx-xx
www.omnexcontrols.com
call toll free: 1-800-663-8806
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Light
Green
Light
Alternating Red
& Green Light
Yellow
Light
Normal Operation
Indicator
Lights
Description
Solution
Indicator
Lights
Description
Solution
Transmitter is OFF
The SW 1 button is
stuck for more than 10
seconds
(If the transmitter is on,
the LINK light will be OFF)
Wiggle the button to try and
get unstuck. If condition
persists, contact customer
service.
During normal opera-
tion, this may indicate
irrecoverable CAN
software error or upon
power-up, out of the
box, the unit has no
setup information or
setup information is
corrupt
Proceed through the
Download ID procedure.
If this doesn’t work contact
Customer Service
Transmitter is OFF
The SW 2 button is
stuck for more than 10
seconds
(If the transmitter is on,
the LINK light will be OFF)
Wiggle the button to try and
get unstuck. If condition
persists, contact customer
service.
Setup download
failed.
Try again, no more than a
couple of times, or contact
customer service.
Transmitter is OFF
A low battery condition
has been detected.
To detect intermittent
conditions caused by
poor or corroded ground
or power circuits, the
GREEN light will continue
to flash for
Transmitter is OFF
E-Stop relay failure
(If the transmitter is ON,
the LINK light will be fast
flashing GREEN)
Contact Customer Service
Trouble Indicators
Note: In some cases, the indicator lights will be different depending on whether the transmitter is on or off. For all cases listed below, the transmitter’s
status is OFF unless otherwise indicated. Please note the transmitter status in the “Description” column for each case.
Diagnostics - R170 Receiver
Indicator
Lights
Transmitter is OFF
If the transmitter is off, the receiver is operating properly. This will be the status of the receiver after the Download
ID procedure as the transmitter automatically shuts off after ID download.
Transmitter is ON
When the transmitter is turned on, the Link light (fast flashing) and E-Stop (GREEN) indicates the receiver is
operating properly
Description
STATUS
LINK
ESTOP
CAN 1
CAN 2
STATUS
LINK
ESTOP
CAN 1
CAN 2
STATUS
LINK
ESTOP
CAN 1
CAN 2
STATUS
LINK
ESTOP
CAN 1
CAN 2
STATUS
LINK
ESTOP
CAN 1
CAN 2
STATUS
LINK
ESTOP
CAN 1
CAN 2
STATUS
LINK
ESTOP
CAN 1
CAN 2
STATUS
LINK
ESTOP
CAN 1
CAN 2
