Optional Equipment
(for qualified installers only)
69
© Travis Industries
4090507
100-01217_000
18
Pull the “RECEIVER” connector through the control panel and attach to the receiver (see Figure
27). Then attach the receiver to the control panel with the two #8 machine screws (see Figure
28).
Figure 27
Figure 28
19
Place batteries into the receiver and transmitter (see Figure 29). Calibrate the receiver to the
transmitter (see Figure 30 - use a paperclip to press the “PRG” button, let it beep, then press any
button on the transmitter – the receiver should beep 5 times – see the operating instructions for
further details).
Figure 29
Figure 30
20
Place the receiver coverplate (and switch) over the receiver (see Figure 31) and attach with the
two screws included with the receiver (see Figure 32)
