OMNITEXT-240 User Manual
P a g e
|
13
7.2.5.2
GPRS setup
To set the GPRS connection it is necessary to enter the APN (Access Point Name). This setting can be
different for each GSM service provider. By default, it is set to
“internet”.
Some providers may also
require username and password.
7.2.5.3
General setup
The section for some general settings.
Writing mode change the alignment in the WEB interface and SMS.
Hostname, System name, System location, and System contact are sent in XML/JSON files and can be
used for flexible identification of the device.
7.2.5.4
Power saving setup
In this section the wake-up (sample) period can be enabled and set. This is required to allow the
OMNITEXT-240 to counter pulses and record digital states Possible options are 0.0625, 0.25, 0.5, 1, 2, 3,
4, 5, 6, 10, 15, 20, and 30 seconds.
A higher setting on this parameter (i.e. 30 Seconds) will allow a longer battery life. Of course, the
reaction of the device gets slower.
7.2.5.5
Device restart
In this section there are tools for full device restart and reset to factory default settings.
7.2.6
Time
For automatic clock synchronization, the controller supports NTP (Network Time Protocol) and
all necessary parameters for automatic synchronization are available in this section.
The clock synchronization is made on
“Interval”
time. If the attempt was not successful, the
next synchronization will be on
“If
not
found”
time.
