OMNI 4000/7000 Operations and Maintenance Guide
– Rev F
6-20
Front Panel Operations
If a Station is running a Common Batch Stack, it will be listed on its
Batch Control
screen (left). The Meter Runs assigned to this stack will display a notice (right) rather
than any batch details (as it would for an Independent Batch).
If a stack is not configured in OMNICONNECT, the flow computer will display
a notice.
5.
a. Continue to view or edit batch stacks,
as needed.
b. When finished, press the
Back
key to
return to the
Batch Operations
screen or the
Home
key to return to
the
Home
screen.
Recalculate Previous Batches
Previous batches may need to be recalculated based on updated volume correction data, such as
%BS&W or reference gravity/density, which is usually determined by laboratory analysis.
To access previous batch records and recalculate them, follow these instructions:
1.
a. From the
Batch Operation
screen,
select
Recalc Prev Batch
.
b. Press
OK
.
