28
AES 2 Sample Rate:
These drop-
down controls select the sample rate for each of the 2 AES/EBU XLR outputs.
Possible settings are
44.1k
(internal 44.1 kHz clock),
48k
(internal 48 kHz clock) or
External
(syncs to the sample
rate of an
AES/EBU signal applied to the External Sync XLR input jack on the rear panel). Sync to
Input
is not
available for AES 2.
If you have AES 1 synced to Input and you also need AES 2 synced to the same source, you
will need to bridge the AES 1 output into the External Sync input and set AES 2 Sample Rate to External.
Livewire
There are 4
similar controls each in the
Livewire 1
and
Livewire 2
groups:
Master
controls the Livewire digital output level of
both the left & right channels simultaneously.
Note:
The
Master control in the
“
Livewire 1 Level
” group
controls the output
level sent to the
Livewire 1
channel configured in the Livewire Setup screen.
Similarly, the Master control in the
“
Livewire 2
Level”
group controls the output
level sent to the
Livewire 2
channel configured in the Livewire Setup
screen.
Right Trim
controls the level of the right channel
only over a l or –
3dB range to correct
left/right balance issues in the following equipment.
This is normally set to “0.0 dB”.
Livewire Output Submenu (Basic Tab)
De-Emphasis
controls whether the appropriate Livewire output (when set to
FM
)
is de-
emphasized (ON) or not
(OFF).
Output Selection
selects the processing channel assigned to that output:
FM, HD, DJ or PP
(Patch Point
–
this will
be the output of the 5-
Band AGC section)
.
Headphone
There is but a single control available here:
Output Selection
selects the processing channel assigned to the front
panel headphone jack:
FM,
HD
or
DJ.
Headphone Output Submenu (Basic Tab)
