38
turning
down the
Auto Sense
control a little. This will allow more clipping to take place. For more in
formation
about clipper Auto Sense, please
see Page 60.
Bass Growl
This is the
next
control that is important to adjust with each preset that you try.
T
his control
is located in both the
Quick Setup
tab and in the
Advanced
tab of the Wide Band /
ENH
menu.
Bass Growl
tunes a number
of behind-the-
scenes parameters at once to tune the Omnia.11 for the desired amount of
bass. Higher settings cause the bass enhancers in the
Basic
tab of the
ENH
menu to be more audible more of the
time. So after making an adjustment to Bass Growl, go back and revisit your Deep/Phat/Warm bass enhancer
settings if needed.
Note that the Deep Bass and Warm Bass controls can also be found in the
Quick Setup
tab. The
Phat Bass
control is only found in the ENH / Basic tab. For more in
formation about
Phat Bass
, please see Page 48.
Brightness
The last 2 basic controls that are important to adjust for each preset tried are the
Presence
and
Treble
brightness
controls.
A setting of “0.0” will add no additional brightness to the selected preset. Turn each up to taste but be careful not to
use more than needed since excessive limiter activity or clipping could occur with very high settings. A little goes a
long way here!
Saving User Presets
Once you have made changes to any parameter, such as the controls in the
Quick Setup
tab discussed above, it is a
good idea to save those changes so they will not be lost. The factory presets cannot be over
-
written so a new user
preset must be created. This is done from the
Preset
tab using the
Save Current As
button.
When you touch
Save Current As
the on-
screen keyboard will pop
-up. Use the on-
screen keyboard to type a name
for your new preset and then touch “OK”. While up to 20 characters can be shown for each preset in the preset list
window, try to keep the preset names short and descriptive if possible.
If you should want to delete a user preset (factory presets cannot be deleted), touch the
Delete
button and a new
window opens containing a list of all of the previously saved user presets. 10 user presets are shown per screen so
use the
PAGE UP
and
PAGE DOWN
buttons if needed to see more user presets.
When you make new changes to an existing user preset, touch the
Save Current
button to save the new changes.
Help Text
The new context
-sensitiv
e help text feature will pop up a box with information about the currently selected control
when that control is highlighted and then the “
?
” button in the lower
-
right hand corner of the menu screen is touched
(or clicked in the remote).
