Performing A Nozzle Check
Performing a Nozzle Check is the final stage of your start-up procedure. This test print will let
you know if all of the ink channels are printing properly, which aren’t (if any), and overall show
whether or not the printer is ready to properly print a clean graphic.
1. Set your platen height.
- Automatic: press FREAR
- Manual: press FRONT until gantry is above the middle
of the platen then UP until the platen stops rising. Then
push STANDBY to move to front.
2. Open the Maintenance tab in your printer’s
Preferences menu on your PC.
3. Click on the “Nozzle Check” option.
4. Click on the “Print” option to initiate the
Nozzle Check.
5. Analyze the print on your platen to ensure
there are no gaps in the lines.
6. Refer to the guide on your PC for good and
bad nozzle check prints
(Continued On The Next Page)
13
Summary of Contents for FREEJET 330TX
