Troubleshooting (Cont’d)
Blinking LED Lights & Error Codes (Cont’d)
Ink Light Blinking
4. (Cont’d) If the Status Monitor shows “Paper Jam” you will need to do the following: Press
the Standby button on the control panel to move the carriage to the front. Once at the front
press the Feeding button. The print head will move and then the carriage will move backwards.
Press the Feeding button one more time to clear the error.
When the ink light is blinking on the printer you do not need to do anything. Because FreeJet
printers use a bulk ink system and not cartridges an ink chip board must be used. The print-
head thinks that cartridges are being used so when the system thinks a cartridge is low or
empty the values need to be reset by the ink chip board. The ink light will flash just before the
reset is completed. Nothing needs to be done by the operator as this is an automated function.
In the case that this does not automatically reset itself, you may manually activate the reset
process by pressing FSTANDBY once to undock the printhead. The printhead will
slowly move away from the Wet Cap Station. Then press FSTANDBY one more
time to return the printhead and initiate the reset process.
If the ink chips do not reset automatically or manually, contact technical support.
When the Ink and Error lights are both flashing together a random error has occurred. This
error is a way of telling you that the printer has gone into a Safety Mode. This is a general error
that can be caused by multiple things any ware from a dirty encoder strip to a board issue. To
fix this the printer will need to be turned off and then back on again, the cause of the error and
when it happens will then need to be diagnosed.
Ink & Error Lights Flashing Together
(Continued On The Next Page)
47
Summary of Contents for FREEJET 330TX
