1-877-98SCOUT
Worldscout Corporation
Page 5 of 11
1-877-987-2688
www.omniscout.com
omniscout Quick Start Guide.doc
2.2 Charging the battery
To install the battery insert the 2 tabs, located at the
bottom of the battery, into the tab hinges located at
the bottom of the omniscout unit. Next, depress the
locking tab at the top of the battery and push the
battery into its seated position.
When inserting a charged battery the omniscout unit
will power ‘ON’.
To charge the omniscout unit, depress (pinch) the locking tabs on both side of
the AC adapter, using your thumb and index finger, and insert into the Adapter
Port located the side of the unit. When fully inserted, release the locking tabs.
When properly connected, the Power Light (left, Red) will blink with a steady
pulse. The AC Adapter must be plugged into an AC outlet.
Normal charge time is approx. 2-4 hours. While charging, the Power Light (on the
left) flashes every 30 seconds. Once the unit is fully charged, the Power Light will
blink with 2 rapid blinks followed by a 30 second (approx.) pause.
Safety Warning: The AC Charging Adapter uses a standard (North American)
110 volt, 15 AMP outlet. Choose a location away from exposure to direct sunlight
and combustible materials.
Locking Tabs