Mounting the Joystick Controller
Identify the desired location of the Joystick Controller.
Use the supplied mounting template decal and create
the necessary openings as indicated on the template.
The Joystick controller has a flush mounting flange
that will sit on a flat surface and sealed with a gasket.
Secure it from under the panel with supplied
hardware as indicated in Fig. 3. The supplied nut can
be fastened with fingers and then tighten with an
appropriate hand tool.
Note:
Please measure the thickness of your mounting
surface and purchase the required length of
these screws if the supplied studs are not used.
Fig. 3
Fig. 4
Joystick Controller Functions
Joystick
Menu navigation and
camera control
Enter
Confirm selection
Menu
Display menu options
Zoom
Adjust zoom
Sensor Select
Toggle between cameras
Function
Programmable key
Color Palette
Select color mode
Radar Track
Activate tracking functions
Power/Standby
Wake, park, or return turret
to home position
All essential functionalities are integrated and accessed via the 8 buttons and
joystick (Fig. 4).
Press any of the button once to activate the menu items on the screen. Use the
joystick to select and cycle-through the options available.
If you are unable to connect to the camera due to the a different set of IP address,
follow this step to configure the camera for Windows user.
1. Go to Settings, then click on Network & Internet.
2. Right-click on your Ethernet Network that is connected to the Junction Box and
click on Properties (Fig. 7).
Change IP Settings
3. On the properties screen, select
Internet
Protocol Version 4 (TCP/IPv4) and click on
Properties (Fig. 8).
4. On IPv4 properties screen, select
Use the
following IP Address option (Fig. 9).
5. Enter the following IP address: 172.16.6.xxx (any
number). As you can see in above image (Fig. 9),
the first 3 number sets (172.16.6) in IP Address
field need to be the same as the Junction Box IP
address. You can only change the last number
set with any number from 1 to 254. Click in the
Subnet Mask area, which should auto-complete.
Click OK (Fig. 9).
Fig. 8
Fig. 9
Fig. 7
6. Launch your web browser and enter the following address
http://172.16.6.225/
and login with the following:
Username: admin
Password: 12345
7. Full control of the camera can be accessed through the Web Interface. You can
configure the IP address to connect to your MFD from the Settings menu.