Omnitracs MCP100 System Verification Form
System Verification
12-20
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
80-J4866-2 Rev. G
For verifying the Performance Monitoring system, the Trailer Tracks system, and other
accessories, see the appropriate chapter in this manual.
Omnitracs
MCP100 System Verification Form
You can make copies of the System Verification Form on the following page and record
important information you may want to keep concerning the vehicle and the MCP100.
14.
Verify that the message can be played with
the RCD by pressing the RCD
Home
key
once and the
center
key twice.
• If the message can be played with the
RCD, go to
• If the message cannot be played with the
RCD, perform the diagnostic procedure in
Chapter 15 in the
MCP100 Diagnostic
Guide.
15.
Turn the vehicle ignition OFF.
16.
Make sure the display unit stays on with the
ignition OFF.
• If the display unit stays on, go to
• If the display unit does not stay on, perform
the diagnostic procedure in Chapter 11 in
the
MCP100 Diagnostic Guide.
17.
Tap the
System
icon. Tap the
System
tab and
verify that the STATUS field changes from
Good
to
Ignition Off
within 10 minutes.
• If the Status changes to Ignition Off within
10 minutes, System Verification is
complete.
• If the Status does not change to Ignition Off
within 10 minutes, perform the diagnostic
procedure in Chapter 12 in the
MCP100
Diagnostic Guide.
05AAA_219E
A
C
C
OF
F ON
STA
R
T
Turn the ignition OFF
