Omnitronic CDT-150, User Manual

10602277_V_1_0.DOC

21/44

6. OPERATION

6.1 Setup

Switch on the CD-player via the Power-switch.

6.2 CD-compartment

Press the Eject-button to open the Disc compartment-door. The door opens. Insert your CD close the
compartment-door. Hold the disc with two fingers on the edge and avoid touching the inside area.

6.3 LCD-display

After inserting the CD, the total number of tracks
and the total playback time are shortly displayed.
The player jumps to the first track and is in the
Pause-mode (Play/Pause-LED flashes). Please
note that the player automatically jumps to the
section where the music starts.

Above "TRACK" the track number is displayed. Above M (MIN), S (SEC) and F (FRAME) the track remain
time is displayed.
By using the Time-button, the time-indication can be switched from track remain time (Remain) to track
playback time (Elapsed) or total remain time (Total Remain).
Above the time-indication, 10 bars are displayed showing the remaining track-time visually. The shorter the
track remain time becomes, the less bars are displayed. 30 seconds before the track-end, the bars in the
display start flashing.
The indication "SINGLE" means that the CD-player is in Single-mode. The current track is then played once
and the player goes into Pause-mode at the beginning of the next track. By pressing the SGL/CTN-button
again, the CD-player changes back into normal playback mode.
The indication "0.0" means that the playback-speed has not been changed. If you adjust the playback-speed
via the Pitchfader (Pitch-button has to be pressed), the respective percentage is indicated in the display.

6.4 Play/Pause

In the Pause-mode the time-indication in the display stands still and the Play/Pause-LED flashes. The
playback of the first track can be started by pressing the Play/Pause button. In the Playback-mode, the time-
indication in the display is running and the Play/Pause-LED shines permanently.
If you wish to interrupt the playback, press the Play/Pause-button and the laser stops at the position where
you stopped.

6.5. Selecting a track via the Track-buttons

You can select the desired track via the Track-buttons.
In order to play a track from the beginning, press the Track-buttons until the desired track number is
displayed. If you hold the respective Track-button, the CD-player will run through the track numbers until you
let the button loose.

-button:

If you press the 

-button once, playback starts at the beginning of the previous track. If a track is already

played back, you can start the current track from the beginning.

-button:

If you press the 

-button once, the playback starts at the beginning of the next track, if you press it twice the

following track, etc.
Please note that the CD-player calls the track up in the mode you pressed the Track-button. If the CD-player
is in the Play-mode at track 1 for example and you press the 

-button, the player jumps to track 2 and

immediately starts playback.