00071453.DOC, Version 1.0
25/30
6. OPERATION
The
DMP-103
can either be operated via the buttons on the front panel or via the remote control.
6.1 Remote control
1
When actuating a button, always direct the remote control towards the sensor. There must be no
obstacles between remote control and the sensor.
2
If the range of the remote control decreases, the batteries are probably exhausted and must be
replaced.
6.2 Switching on
1
Switch on the
DMP-103
with the power button.
2
The display shows the station number last selected and the corresponding receiving frequency. If a
program is transmitted in stereo, the indication STEREO appears in the display.
3
The CD player will automatically detect if a CD is inserted (indication LOAD CD). If an audio CD is
inserted, the display will shortly indicate the total number of titles and the total remain time followed by
information concerning the first title after the read-in. For MP3 CDs the total number of folders and titles
of the first folder will shortly be displayed. If no CD is inserted "NoDisc" will be displayed.
4
For muting the sound, press the button
MUTE
(indication MUTE). To switch on the sound again, press
the button
MUTE
once again.
6.3 Tuner operation
Station tuning
To store stations, 40 storage locations are available in the FM range and 40 further storage locations in the
AM range.
1
Switch to FM reception (indication FM) or AM reception (indication AM) with the buttons
AM
and
FM
.
2
Long actuation of the button
TUNING [+]
(forwards) or
TUNING [-]
(reverse) starts automatic station
finding. The station finding stops as soon as a station is found. Start the station finding so many times
until the desired station will be received.
3
For manual fine tuning, shortly press the button
TUNING [+]
or
[-]
to increase or reduce the received
frequency step by step.
Storing stations
1
Select the storage location (the station number) for the station tuned:
• either in steps with the buttons
STATION [+]
and
[-]
or
• directly with the station buttons
1
to
4
. By pressing the button
+5
the unit will advance 5 stations. For
direct selection of place 5 shortly press button
+5
once, for place 10 shortly press button
+5
twice. For
places 6 to 9 shortly press button
+5
and then the corresponding station button.
2
Tune to a station as described in the previous section.
3
Press the button
MEMORY
. The station number flashes in the display which signalizes the storage
mode.
Press the button
MEMORY
again to complete the storage procedure.
Automatic station memory
Stations with good reception can also be stored with the automatic station memory. Pressing the button
AUTO SCAN
starts the automatic station memory. The automatic station memory will be running forward
and store six stations in the memory. Stations will only be stored in the selected band.
