Omnitronic XO-2300, User Manual

10304055_EF.DOC

9/20

Example for setting the frequency ranges (depending on the system and the room):

Bass

Highs

100 Hz - 10 kHz

100 Hz - 10 kHz

The frequency can be adjusted via the Frequency-control, depending on the Range-switch between 100 Hz
and 1000 Hz or between 1 kHz or 10 kHz (LED lit).

With the Gain-control, you can boost the incoming signal level by up to 15 dB.

With the Low Level and High Level controls, you can attenuate the respective output level in order to avoid
amplifier distorsion.

In the stero mode, both channels should be adjusted the same way.

3-way mono operation

Please switch the stereo/mono switch to 3-way mono.
Please adjust the desired seperation frequency between mids and highs via the Frequency-control mid/high.
Make sure that the range-switch is switched to 1:10. The frequency range ranges from 1 kHz to 10 kHz.

The portion of the mids can then be cut via the Mid Level-control.
The portion of the highs can then be cut via the High Level-control.

Example for setting the frequency ranges (depending on the system and the room):

Bass

Mids

Highs

20-550 Hz

550-6000 Hz

6000-18000 Hz

Please adjust the desired seperation frequency between lows and mids via the Frequency-control low/mid.
Make sure that the relation-switch is switched to 1:1. The frequency range ranges from 100 Hz to 1000 Hz.
The portion of the bass can then be cut via the Low Level-control.