Define suitable places for water purifier
OMOIKIRI Pure drop 2.1.4S. Make sure that
connecting tubes are attached freely without
crippling.
Water purifier OMOIKIRI Pure drop 2.1.4S
should be placed at a distance and isolated
from heat sources (kitchen source, boilers,
hot water pipes, dishwashers, washing
machines and others).
INSTALLATION
ATTENTION!
It is recommended
that the installation is realized by the
specialists, who have work
authorization.
JG 3/8”
1.
Connection point, inlet valve «Close».
2.
Cold water main.
3.
Drainage clamp.
JG 1/4”
with pressed
metal plug
JG 1/4”
water direction
JG 1/4”
Turn the water off at the mainline.
Turn on the kitchen tap to depressurize the
water system.
Install the connection point into the water
system. In case of need use the plumber's
tape to thicken the outer thread.
Connect the JG blue pipe.
Pull out the locking clip under the plastic
housing and set moistened jet into the
housing of the fitting up to the stop position
at a depth of 15 mm and put the clip back.
Check the pipe fastening is right. When it is
pressure 8-10 KGS pipe does not pull-out.
CONNECTION POINT INSTALLATION
ATTENTION!
The sealing gasket must not be
without damagedand must be placed on its
right place.
cold water main
connection
point
inlet valve «Close»
sealing
gasket
locking
clip
13
1
2
3
Manufacturer reserves the right to use junction points and taps of the similar construction. In case of need, please
contact the service provider.