6 Troubleshooting
6 - 10
CompoNet Communications Unit User’s Manual (I582-E1)
6-4
Errors Related to Message Communi-
cations
To send a CompoNet Explicit Message from a CS/CJ-series unit, use a FINS message.
If any Explicit Message/FINS message is not completed normally, check the contents of the FINS mes-
sage response.
The table below shows the assumed cause and corrective action for each FINS response.
Additional Information
For details about FINS commands not described above, refer to CS/CJ-series Communica-
tions Commands Reference Manual (Cat. No. W342).
6-4-1
FINS Message Errors (CS/CJ-series)
FINS
Response
Description
Assumed Cause
Corrective Action
0000
Normal comple-
tion
–
–
0101
Local node not in
network
Local node is not in network.
Check Master Unit settings and network
configuration.
0201
Destination node
not in network
Destination node is not in net-
work.
(MS and NS LED indicators not
indicating normal state)
Add destination node correctly to the net-
work.
0204
Destination node
is busy.
Destination node receives too
much data.
Increase number of resends or review sys-
tem so that the destination node does not
receive so many messages.
0205
Response timeout Response monitor time is too
short.
Increase length of response monitor time.
Message frame was destroyed
by noise.
Check noise conditions and take corrective
action.
Increase number of resends.
1001
Command too
long
Command is too long.
Check command format and correct com-
mand data.
1002
Command too
short
Command is too short.
Check command format and correct com-
mand data.
1004
Command
format error
Incorrect format is used.
Check command format and correct com-
mand data.
1005
Header error
Destination address setting
(routing table) is incorrect.
Check FINS command (2802) in CMND
instruction.
Set routing table correctly.
110B
Response too
long
Response is longer than maxi-
mum frame length.
Check command format and set correct
number of elements.
2609
Necessary items
not set
Required elements are not set in
command data.
Check command format and set required
elements in command data.
Summary of Contents for 3G3AX-MX2-CRT-E
