Intended Use of the Robots
Adept Viper s1300 Robot User’s Guide, Rev B
13
1.6
Intended Use of the Robots
The Adept Viper robots are intended for use in parts assembly and material handling for
payloads less than 10 kg. See
for complete information on tooling and
payloads.
1.7
Installation Overview
The system installation process is summarized in the following table. Refer also to the
system cable diagram in
NOTE:
For dual-robot installations, see the
, which is available in the Adept Document
Library.
1.8
Manufacturer’s Declaration
The Manufacturer’s Declaration of Incorporation and Conformity lists all standards for
which the Adept Viper robot system complies. It can be found on the Adept Web site, in
the Download Center of the Support section.
ftp://ftp1.adept.com/Download-Library/Manufacturer-Declarations/
Each Manufacturer's Declaration is supplied in PDF format and stored on the website in a
ZIP archive. To access the PDF document:
1. Click on the appropriate .zip file. You are prompted to Open or Save the file.
2. Click Open to open the file and display the archive contents.
3. Double-click on a .pdf file to open it.
Table 1-1. Installation Overview
Task to be Performed
Reference Location
1. Mount the robot on a flat, secure mounting surface.
See
.
2. Install the SmartController, Front Panel, and Adept
ACE™ software.
See
.
3. Install the PA-4 power chassis.
See
.
4. Install the Arm Power/Signal cable between the
PA-4 and the robot.
See
5. Install the IEEE 1394 and XSYS cables between
the PA-4 and SmartController.
See
6. Connect AC power to PA-4 power chassis.
See
7. Start the Adept ACE software, connect to the
controller, and turn on power to the system.
See
