8 Using the UPS monitoring software
8-1 The outline on the UPS monitoring software
BW40T/BW55T/BW100T/BW120T
50
8 Using the UPS monitoring software
When using the UPS monitoring software, connect and set as the followings.
8-1 The outline on the UPS monitoring software
When an input power supply abnormality (power failure, etc.) occurs, UPS monitoring
software can be used for shutting down connected computers. According to usage,
download and use necessary software from our home page:
(http://www.omron.co.jp/ese/ups/support/download/download.html). Refer to the following
table for the response situation for OS.
Notes
When manually starting during the scheduled operation using the UPS
monitoring software
To manually start up this unit after it has been stopped by a scheduled operation,
turn OFF the power switch and turn it back ON again. To manually stop the unit
during the scheduled operation, turn OFF the power switch.
Under the setting of auto stop the UPS after OS closing processing,
when the power is restored while auto shutdown processing is being
performed
If a power failure occurs and then the power is restored while auto shutdown is still
in progress, UPS output will stop temporarily after the set time elapses. After
shutdown is finished, do not turn on the computer until the UPS has finished
restarting.
