51
Wiring
Section 3-3
3.
When soldering, take care not to short the terminal to the neighboring one.
Cover the soldered part with an insulating tube.
Note
Be sure to check that the output power supply is not connected in reverse.
4.
Assemble the connector (included or purchased separately) as shown be-
low. The shape of the 40-pin connector is different to that shown in the di-
agram.
Hook
After wiring
Remove the label.
Soldered-type connector
included with Unit
Insulating tube
Wire (0.2 to 0.13 mm
2
)
Connector cover
Small screws (3)
Small screws (2)
Connector lock screw
Cable clamp
Nuts (2)
Nuts (3)
Socket
Summary of Contents for CS1W-HCA12-V1
