45
Import
Section 6-3
6-3
Import
Importing File
Files saved in CSV format can be imported as project data.
If a CSV file contains Unit and Servo Parameters, the axis map in the
imported file will be adopted.
If a CSV file contains Servo Parameters only, a new Servo Drive will be added
to the axis map. In this case, the lowest axis No. not in use will be allocated to
the Servo Drive automatically.
In the Axis Map Setting Window, select
File - Import
, or right-click a Position
Control Unit and select
Import
from the pop-up menu.
6-4
Export
Exporting All Data
Unit Parameters and registered Servo Parameters can be saved in CSV for-
mat.
Select a Position Control Unit in the Axis Map Setting Window, and then select
File - Export
, or right-click the Position Control Unit and select
Export
from
the pop-up menu.
Note
Files exported from CX-Motion-NCF version 1.4 or higher cannot be imported
to CX-Motion-NCF version 1.3 or lower. Set the
Save as type
Box to
Unit
Parameter file in Ver1.3 or lower
to export a file that can be imported to CX-
Motion-NCF version 1.3 or lower.
Unit Parameter file in Ver1.3 or lower
can be
set only when the Unit is the CS1W-NCF71/CJ1W-NCF71 (the axis type is
16).
Summary of Contents for CX-MOTION-NCF - V1.8
