F-36
Small Sealed Switch
D4E-
@
N
Nomenclature
Bearing
Built-in Switch
Die-cast Case
Movable Plunger
Rubber Cap (NBR)
Seal Packing (NBR)
Terminal Protection Cover
Screw Terminal
Wiring Ease
Rubber cap provides a tight seal and
ensures a long service life and
smooth reset at low temperatures.
Seal packing withstands a pressure of
186 kPa (D4E's seal packing with-
stands a pressure of 98 kPa).
D4E-
@
N has a wide wiring space of
10 mm horizontally (D4E has a space
of 7.5 mm horizontally).
Screw terminal incorporates a M3
screw with a toothed washer.
The actuator strength has been increased to 4,903 N
(D4E: 294 N) in order to prevent faulty resetting of
the bearing, which may occur when the roller is
pressed with excessive force.
Switch cover ensures high insulation between the
terminals and die-cast. Double insulation means that
grounding is unnecessary. Meets UL, CSA, and EN
standards.
Prevents the movable piece from being pushed in
too far, and thereby contributes to a longer service
life.
Zinc die-cast case is anti-corrosive and tough.
Wired made easier using (D4CC-type)
plug-in connector.
