2. Part Name and Function
2-10
<Inserting SD memory card>
( *)
(1) Insert an SD memory card into the SD memory
card slot with the metal terminal facing up.
(2) Push the card inward until it clicks.
(3) "SD" appears on the display.
<Removing the SD Memory Card>
(1) Push the inserted SD memory card inward until it clicks.
(2) Stop pushing and let the card pops out. Be careful not to drop it.
(3) "SD" on the display disappears.
Important
・
If an SD memory card is unformatted, format it before inserting it into the SD card slot.
・
For SD memory card format software distribution page, refer to the following URL.
https://www.sdcard.org/downloads/formatter_4/
2.3.3 Input/Output Specifications
(1)
Alarm Output
<Alarm Output Terminal>
(1) OUT
Outputs the results allocated in THR mode.
(2) GND
A common terminal.
The terminal names are inscribed on the unit.
Use the provided alarm output connector for wiring.
<Output Specifications>
External Power Supply Voltage
DC12
～
24 V ±10%
Load Current
Max. 45 mA
ON Residual Voltage
Max. 1.2 V
OFF Leakage Current
Max. 0.1 mA
Internal Circuit Diagram
Important
・
Do not connect the external power supply directly between OUT and GND.
・
Be sure to connect a load.
Load
External
Power
Supply
