CHAPTER 1 INTRODUCTION
E5CK
1--8
•
If you select [
] [
] [
] or [
] in the menu display, the
setup, expansion, option and calibration modes, respectively, are
selected.
•
When these modes are selected, the control is reset. So, control outputs
and auxiliary output are turned OFF. When another mode is selected
while in these modes, reset is canceled.
•
To set the controller to the protect mode or to return to the level 0 mode
from the protect mode, press the
A/M
key and
key for 1 second mini-
mun simultaneously.
•
To set the controller to the manual mode, press the
A/M
key for 1 second
minimun in the level 0 to 2 mode. To return to the level 0 mode from the
manual mode, press the
A/M
key for 1 second minimum.
•
When not in the manual mode, each press of the
key switches the
parameter.
•
If you press the
key when at the final parameter, the display returns
to the first parameter.
Parameter
1
Parameter
2
Parameter
3
Parameter
n
•
When you have changed a parameter setting, specify the parameter
using the
or
keys, and either leave the setting for at least two
seconds or press the
key. This fixes the setting.
•
When another mode is selected, the content of the parameters before the
mode was selected is fixed.
•
When turning the power OFF, you must first fix the settings and param-
eter contents (by pressing the
key or selecting another mode). The
settings and parameter contents are sometimes not changed by merely
pressing the
or
keys.
F
Setup mode
F
Expansion mode
F
Option mode
F
Calibration mode
F
Protect mode
F
Manual mode
J
Selecting
parameters
J
Fixing settings
