CHAPTER 2 PREPARATIONS
E5CK
2--2
2.1 Setting up
This section describes how to set the input type jumper, and set up the out-
put unit or option unit.
First, draw out the internal mechanism from the housing
(1) Pull out the internal mechanism while pressing the hooks on the left
and right sides of the front panel.
(2) Draw out the internal mechanism towards you holding both sides of
the front panel.
J
Setting the input type
•
For details on the jumper connector position, see page 1-2.
•
Set the input type jumper connector to one of temperature input, voltage
input or current input matched to the sensor connected to the input ter-
minal.
I : Current input
V : Voltage input
TC.PT : Temperature input
•
The factory setting is “TC/PT (temperature input).”
•
When removing or inserting the jumper connector, do not touch the pins
directly with your fingers.
•
When you have set the jumper connector, insert the internal mechanism
into the rear case.
•
When inserting the internal mechanism, push in until you hear the
hooks on the front panel click into place.
J
Draw-out
