CHAPTER 5 PARAMETERS
E5CK
5--32
•
The parameters in this mode can be used only when the “security” parameter (pro-
tect mode) is set to “0” and “1”.
•
You can select this mode only when the option unit is set in the controller. In this
mode, you can set the communications conditions, transfer output and event input
parameters to match the type of option unit set in the controller.
•
To select this mode when in the levels 0 to 2, setup, expansion and calibration modes,
press the
key for 1 second minimum. The display changes to the menu display.
If you select [
] using the
key then press the
key for 1 second mini-
mum, the controller enters the option mode.
•
To select parameters in this mode, press the
key. To change parameter settings,
use the
or
keys.
•
The following table shows the parameters supported in this mode and the page where
the parameter is described.
Symbol
Parameter Name
Page
Multi-SP function
5-33
Event input assignment 1
5-33
Communication stop bit
5-34
Communication data length
5-34
Communication parity
5-34
Communication baud rate
5-34
Communication unit No.
5-34
Transfer output type
5-35
Transfer output upper limit
5-35
Transfer output lower limit
5-35
Option Mode
