Multipoint Temperature Controller
E5ZE-8
@D1@B-V2
7
Precautions
Mounting the Controllers
Side-by-side, Close Mounting
Saves space and improves wiring efficiency.
Wall Mounting
Can be mounted to places with limited depth.
General Mounting Precautions
The side of the E5ZE with the terminal block and connectors must
not face up, otherwise operating errors may result.
Prepare four M4 screws to mount the E5ZE to control panels. Use
flat washers and spring washers with screws to mount the E5ZE to
control panels so that the screws will not loosen.
The mounting brackets must be attached to the E5ZE with the four
M3
×
6 screws provided with the E5ZE and each of the screws should
be tightened to a torque of 0.43 to 0.58 N·m, or 4.4 to 5.9 kgf·cm.
Do not mount as shown in the following diagram.
Control panel
Up
Control panel
Up
Control panel
Incorrect
