20
19
5.
Setting Procedure
Checking the degree of
suitability of the model
Teaching successful
Teaching unsuccessful
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
Optimum
for a
model
Buzzer
sounds
Buzzer
sounds
Not fit for
a model
Locate the sensing object in the
sensing area so that the degree
of suitability for a model will be
indicated.
The level indicators are all lit for
0.5s and the buzzer sounds
twice.
The threshold indicators all flash
while the buzzer sounds four times.
The contrast is insufficient. Change
the location of the Sencor and try
again.
Press the
teach/display
button .
Press the teach/display button after locating
the sensing object in the sensing area.
6
Measurement Items: PATT/BANK
5.1 TEACH Mode
Set the mode selector to TEACH.
Set the measurement item/bank number
selection switch to PATT/BANK.
Bank No. 0 will be displayed.
Press the UP/DOWN select buttons to set
the bank number.
Use the measurement item (bank number)
selection switch to set the measurement method.
Make the automatic teaching and model size
settings on the DIP switch.
If using an F10-C30/C35/C50/C55, go to
step
to set the bank number.
If using an F10-C20/C25, go to step
Banks
Each F10-C30/C35/C50/C55
Sensor has eight banks for
storing data, and a different
threshold value can be stored
in each of the eight banks.
Use this function to take
measurements under various
conditions. You can switch
operation simply by switching
banks.
1
2
3
3
5
4
5
形F10-C20/C25/C30/C35/C50/C55 02.11.19 10:12 AM ページ 19
