58
Dimension
Section 3-4
The settings operation is shown in the following diagram. Only the outline will
be given here. Follow the instructions given by the operational guide on the
Monitor screen.
3-4-1
Selecting Dimension
Select Dimns’n on the screen for selecting inspection types.
3-4-2
Setting Inspection Details
1.
Select whether the range for OK items will be set in physical units.
CHECK
This screen will not be displayed if the coordinate system has already been
aligned in another inspection region.
Select
Dimns/n.
Set inspection
details.
Yes
1
2
Physical units
for OK item
range?
1.
2.
Specify
origin
coordinate
system.
Specify
direction
coordinate
system.
Specify
magnifi-
cation.
Add
inspection
details.
Specify
2nd
position.
4.
Specify
1st
position.
Sepcify
OK item
range.
5.
6.
3.
9.
8.
7.
Add
End
Return to
screen to
selecte type
of inspection.
STEP
4
0.Scn 0 =SET= Region
Select the type of
inspection.
(Up to 32 regions)
S+ENT:Help S+
←→
:Switch display
Start
Ref image
>>Region
Position
End
Presence
Orient'n
Dimens'n
Surface
Conform
Position
Chip/Bur
Back
Yes
Back
No
Do you want to set the
range in physical units?
0.Scn 0 =SET= Region
0.Dimens'n
Summary of Contents for F160 Vision Sensor
