6
2.4
To change the temperature from °C to °F
The thermometer default is set to Celsius °C. It is possible to measure the
temperature in °C or °F. To change the unit of temperature from °C
(Centigrade) to °F (Fahrenheit) follow the procedure shown below.
1
The GentleTemp 510 ‚ is off and the display is blank.
2
Press and hold the blue button for approx. 4 seconds.
During this period all the symbols on the display illuminate.
Next a large C flashes on the LCD.
3
Remove your finger from the blue button.
4
Each time the button is pressed a large C or a large F is
displayed alternatively.
5
Remove your finger from the blue button.
6
Five ( 5) seconds after pressing, the thermometer turns
off automatically. The display is blank.
7
The thermometer is now set for the Fahrenheit (°F) mode.
To select Celsius (°C) mode, start from Step 1.
2.5 Recommendations
Store the unit in the room where you are going to use it.
If the unit has been stored in a cool (cold) room, allow it to reach ambient
temperature before using (temperature of the environment needs to be
above 10 °C or keep the thermometer at least 30 minutes in the place
where you are going to use it). Do not warm the unit by placing it near a fire.
Instead, place it in the room where you are going to use it to allow it to reach
the room temperature.
Start measurement after the body (ear) is warmed up.
The measurement may indicate a lower temperature than the actual
temperature in the following cases:
• Immediately after returning to your home (especially in winter).
• In a cool or cold room.
• When the head (ear) is cooled by an ice bag.
Confirm the measuring method by familiarizing yourself with the best way
to insert the unit in the ear. Do this during normal body temperature periods.
• Note the angle you are holding the thermometer at when the highest
measurement value is indicated.
• The measurement value may differ for each ear. Try to measure the
temperature using the ear that shows the highest temperature in stable
conditions.
GentleTemp 510
English
13413 MC-510-E2_ver.6_MC-510-E2 10/04/2013 17:20 Page 6