18
Solid-state Timer
H3BA-N
PL Socket
1.
Secure the Socket to the panel surface with screws and insert the
F-shaped hook into the sockets.
2.
Connect the Timer to the Socket and press the tip of each hook
by hand.
Panel Mounting
When the Y92F-30 Flush Mounting Adapter is used, insert the Timer
into the square hole from the front side of the panel and put on the
Flush Mounting Adapter from the rear side of the Timer. Press the
Flush Mounting Adapter so that the space between the Flush
Mounting Adapter and the panel is reduced as much as possible,
and secure the Flush Mounting Adapter with screws.
When using the US08, be sure to use 10.5-dia. max. multi-conductor
cable or 3-dia. max. insulated stranded wire for wiring.
When the Y92F-40, Y92F-70 or Y92F-71 Flush Mounting Adapter is
used, just insert the Timer into the square panel hole. If the panel
coating is too thick and the hooks do not click, spread open the
hooks appropriately to the left and right after inserting the Timer to
the hole.
■
Dismounting
Surface Mounting with P2CF
Panel Mounting
Loosen the screws of the Flush Mounting Adapter, spread open the
hooks, and remove the Mounting Adapter.
When the Y92F-40, Y92F-70, Y92F-71 Mounting Adapter is used,
press the hook inwards with the thumb and index finger of both
hands, and press the Timer towards the front side.
Panel
Screw
Y92F-30
Spread open the hooks to the left and right.
Spread open the hooks to the left and right.
Panel
The illustration is an ex
ample with the Y92F-70.
Summary of Contents for H3BA-N
Page 19: ...Solid state Timer H3BA N 19 ...
